Notes: 1. This template is an addition to the device template. Locate centerlines using horizontal and vertical references on device template. 2. Do not scale drawing. 3. Dimensions are in inches (mm). 4. LHR door shown. Preparation is typical for both door hands. 5. For door reinforcement, see template T30800. 6. Prepare mounting holes when installing trim. 7. Provide adequate internal support to prevent door deformation from bolting trim to the device. 8. Dimensions given about a centerline are symmetrical. 9. Unspecified radii 1/8 (3) maximum. RESPONSIBILITY DOOR AND FRAME MANUFACTURERS ARE RESPONSIBLE FOR PROVIDING ADEQUATE TH955 & TH959 Trim OUTSIDE FACE OF DOOR X 1-3/8 (35) 3-5/8 (92) 3-5/8 (92) X 9-15/16 (252) CL CL 1/2 (13) Dia. Inside Face Of Door 2-5/8 (67) 11/16 (17.5) Section X - X Horizontal Reference (Device Centerline) Cutout Outside Face 3/4 (19) Radius 2-1/8 (54) Vertical Reference (Trim Centerline) 1/2 (13) Dia. Outside Face 5/16 (8) Dia Inside Face 7/8 (5 Places) (22) 3/8 (9.5) Dia. Outside Face TH955 TH959

CONSTRUCTION OR REINFORCEMENTS FOR PROPER INSTALLATION OF HARDWARE SHOWN. ALL ARCHITECTURAL BUILDERS HARDWARE MUST BE INSTALLED ON PROPERLY REINFORCED DOORS AND FRAMES, REGARDLESS OF TYPE, MATERIAL, OR METHOD OF CONSTRUCTION.

Metal Door Preparation With ED5200, ED5400 or ED5800 Series Rim and Vertical Rod Exit Devices

DO NOT SCALE DRAWING SUPERSEDES TEMPLATE NUMBER SHEET DATE T31012 1 of 1 02/23 www.corbinrusswin.com