Original Source Document Full PDF Version
View PDF
← Corbin

Notes:

  • Backset is measured from centerline of bevel which is centerpoint of door thickness.
  • (*) When preparing doors for lead wrapped locks, add 1/8 (3.2) to dimensions marked (*) to allow proper clearance.
  • 1-1/8 (28.6) strike lip suits frame for 1-3/4 (44.5) thick door, lip will vary for other door thicknesses.
  • For preparation of trim, refer to separate template.
  • Dimensions given in inches and (mm).
  • For open back strike, refer to template T30606.

Corbin Russwin Museo Trim M30 Half Trim for ML2000 Series Mortise Locks Template_T31162 image on page 1

(2)

Corbin Russwin Museo Trim M30 Half Trim for ML2000 Series Mortise Locks Template_T31162 diagram on page 1

FRAME DETAIL
ANSI Strike Description
236L72 Latch & Dead Bolt Holes
236L73 Latch Bolt Hole Only
236L74 Dead Bolt Hole Only
And Optional Box 120F76
G Н J Door Thickness
1-1/4 (31.8) 1-3/4 Min (44.5) Standard
1-1/16 (27) 17/32 (13.5) 1-1/32 (26.2) 1-3/8 (34.9) Optional
Tolerances
Inches (mm)
.005 (.127)
.015 (.381)

1 of

08/22

RESPONSIBILITY

DOOR AND FRAME MANUFACTURERS ARE RESPONSIBLE FOR PROVIDING ADEQUATE CONSTRUCTION OR REINFORCEMENTS FOR PROPER INSTALLATION OF HARDWARE SHOWN. ALL ARCHITECTURAL BUILDERS HARDWARE MUST BE INSTALLED ON PROPERLY REINFORCED DOORS AND FRAMES, REGARDLESS OF TYPE, MATERIAL, OR METHOD OF CONSTRUCTION.

MUSEO® Trim ML2000 Series Half Trim Option M30

Corbin Russwin Museo Trim M30 Half Trim for ML2000 Series Mortise Locks Template_T31162 image on page 1

assa abloy

SUPERSEDES T31162-2 DO NOT SCALE DRAWING TEMPLATE NUMBER