← Corbin
Notes:
- Backset is measured from centerline of bevel which is centerpoint of door thickness.
- 2. (*) When preparing doors for lead wrapped locks, add 1/8 (3.2) to dimensions marked (*) to allow proper clearance.
- 1-1/8 (28.6) strike lip suits frame for 1-3/4 (44.5) thick door, lip will vary for other door thicknesses.
- For preparation of trim, refer to separate template. 4.
- Dimensions given in inches and (mm).
- For open back strike, refer to template T30606.
| Function | Α | В | C | |
|---|---|---|---|---|
| ML 2010 | ||||
| ML 2020 | • | |||
| ML 2022 | • | |||
| ML 2024 | • | • | ||
| ML 2029 | • | • | ||
| ML 2030 | • | |||
| ML 2032 | • | |||
| (7 ) | ML 2049 | • | • | |
| ML 2052 | • | |||
| ML 2053 | • | • | ||
| ML 2055 | • | |||
| ML 2056 | • | |||
| ML 2057 | • | |||
| ML 2058 | • | • | ||
| ML 2059 | • | |||
| ML 2062 | • | |||
| ML 2065 | • | • | ||
Series
| A = | CYL O/S | |
|---|---|---|
| B= | CYL BOTH SIDES | |
| C= | TP I/S | |
Required Holes
| FRAME DETAIL | ||||
|---|---|---|---|---|
| ANSI Strike | • | |||
| 236L72 | Latch & Dead Bolt Holes | |||
| 236L73 | Latch Bolt Hole Only | |||
| 236L74 | Dead Bolt Hole Only | |||
| And Optional Box 120F76 | ||||
| E | F | G | Door Thickness |
|---|---|---|---|
| 1-1/4 (31.8) | 5/8 (15.9) | 1-1/16 (27) | 1-3/4 (44.5) or Over (Std) |
| 1-1/16 (27) | 17/32 (13.5) | 1-1/32 (26.2) | 1-3/8 (34.9) (D138) |
| Tolerances | |||
|---|---|---|---|
| Inches | (mm) | ||
| .005 | (.127) | ||
| .015 | (.381) | ||
RESPONSIBILITY
DOOR AND FRAME MANUFACTURERS ARE RESPONSIBLE FOR PROVIDING ADEQUATE CONSTRUCTION OR REINFORCEMENTS FOR PROPER INSTALLATION OF HARDWARE SHOWN. ALL ARCHITECTURAL BUILDERS HARDWARE MUST BE INSTALLED ON PROPERLY REINFORCED DOORS AND FRAMES. REGARDLESS OF TYPE. MATERIAL, OR METHOD OF CONSTRUCTION.
ML2000 Series by M30 Mortise Lock by Half Trim
Corbin 7/Russwin 7/
assa abloy
SUPERSEDES T30607-7 DO NOT SCALE DRAWING 08/22 30607-8