Installation Instructions

FE6800 Series Multi-Point Lock

In U.S.: Corbin Russwin, Inc. 225 Episcopal Road Berlin, CT 06037 USA www.corbinrusswin.com

ASSA ABLOY In Canada: ASSA ABLOY Door Security Solutions Canada 160 Four Valley Drive Vaughan, Ontario, Canada L4K4T9

Technical Product Support: Phone: 888-607-5703

www.assaabloy.ca

ASSA ABLOY

This device is intended to be part of an integrated door, frame and hardware assembly UL-approved for both FEMA 361 and FEMA 320 guidelines for both in-swing and out-swing doors.

VERIFY HANDING

VERIFY DOOR DIMENSIONS

ASSA ABLOY

WARNING

LOCK IN condition can occur and EMERGENCY EGRESS will be prevented if critical dimensions are not met.

Device will not operate, if door cutouts are not within the

1. INSTALL DEADBOLT ASSEMBLY

Deadbolt must be retracted before moving to the next step.

2. INSTALL BOTTOM BOLT ASSEMBLY

3. ALIGN BOTTOM BOLT ASSEMBLY

4. PREP TOP ASSEMBLY

5

MARK CLOSEST HOLE

5. INSTALL TOP ASSEMBLY

6. ALIGN TOP & BOTTOM ROD PINNING HOLES

Pin Holes

6a. ADJUST MISALIGNED PINNING HOLES UP

Adjust Plunger If Necessary

6b. ADJUST MISALIGNED PINNING HOLES DOWN

Adjust Plunger If Necessary

7. PIN THREE ASSEMBLIES

ASSA ABLOY

8. MOUNT DOOR TO FRAME

9. CHECK FOR HOLD OPEN

10. ADJUST DEVICE

Plunger Rotations

11. TRIGGER DEVICE & FINAL CHECK

ASSA ABLOY

GO BACK TO STEP 10 GO BACK TO STEP 10

12. ASSEMBLE CYLINDER INTO OUTSIDE TRIM

ASSA ABLOY

13. MOUNT OUTSIDE AND INSIDE TRIM

14. INSTALL TOP LATCH INTO DOOR FRAME

15. ATTACH DEADBOLT STRIKE PLATE TO FRAME

16. PREPARE FLOOR FOR BOTTOM STRIKE

17. INSTALL BOTTOM STRIKE

ASSA ABLOY

18. TEST INSTALLATION