Notes:

• Minimum Stile Width 4-1/2(114).
• For recommended door reinforcements see template T30800. Unreinforced doors require optional SNB to mount the device components.
• Unless otherwise specified, door and frame preparation and dimensional tolerances must conform to ANSI A115.1. Lock support required as shown.
• 4. For outside trim preparation see appropriate trim template.
• 5. Prepare mounting holes when installing the device.
• LHR door shown. Preparation is typical for both door hands.
• 7. Dimensions are in inches (mm). Do not scale drawing.

• Holes for optional SNB: 9/32(7.00)Dia. inside door face; 3/8(9.50) Dia. outside door face.
• 9. Dimensions given about a centerline are symmetrical.
• 10. Device mount to hinge stile (not shown) requires holes location and preparation during device installation.
• For electrical device suffixes "-Safe", "-Secure", M91, or M93: ½ (12.70) diameter, this face, plus prep shown on template T30890.
• 12. For electrical device suffixes M92, M94, or M97 also see template T30890.
• 13. Latchbolt centerline is 23/32 (18.2) below & Auxbolt centerline is 3/16 (4.8) above the centerline of lockfront.

ED5600 & ED5600A Series Mortise Exit Devices with ANSI A115.1 Strike Application for Metal Door and Frame

www.corbinrusswin.com SUPERSEDES T 30809-1 DO NOT SCALE DRAWING TEMPLATE NUMBER T30809-2 DATE 1-04