Installation Instructions for 5100 Alarmed Exit Device

INSTRUCTIONS FOR INSTALLING SARGENT, 5100 SERIES 04 FUNCTION ALARMED EXIT LOCK ■ FOR OUTSIDE CYLINDER OPERATION WITH OR WITHOUT OUTSIDE PULL TRIM FOR 10 FUNCTION BRACKET SEE OTHER SIDE OF PAGE CAUTION: BEFORE STARTING DOOR SHOULD BE FITTED AND HUNG CHECK HAND—CHASSIS IS NORMALLY CHASSIS ASSEMBLED FOR A RIGHT HAND REVERSE BEVEL DOOR AT THE FACTORY HORIZONTAL REFERENCE LINE (C CHASSIS) RIGHT HAND LEFT HAND REVERSE BEVFI REVERSE BEVEL (BHBB) TO CHANGE HAND COVER 1 REMOVE RETAINING RING CONTAINS CYLINDER HUB AND CYLINDER HUB. ELECTRONIC AND ALARM EXTRA RETAINING 2. REMOVE PIVOT PIN AND BING FURNISHED MODULE LATCH BOLT LEVER. IN SCREW PACK 3. REASSEMBLE PARTS IN REVERSE ORDER AT 0 STRIKE VERTICAL OPPOSITE END. REFERENCE LINE USE STANDARD ( C CHASSIS) MORTISE CYLINDERS HAVING THE FOLLOWING PIVOT PIN DIMENSIONS: NOTE: IF OUTSIDE CYLINDER IS NOT LONGER CAMS LATCH BOLT USED-REMOVE RETAINING CAN BE RIGHT HAND REVERSE RING, CYLINDER HUB LEVER MODIFIED TO PIVOT PIN AND LATCH CYLINDER HUB BEVEL ILLUSTRATED BOLT LEVER. USE INSTRUC-(2) CLEAR POSTS TIONS FOR 10 FUNCTION LENGTH CAM ON OTHER SIDE OF PAGE MARK VERTICAL AND HORIZONTAL ASSEMBLE CYLINDER REFERENCE LINES ON DOOR CYLINDER CAM DETERMINE LOCATION OF VERTICAL-ASSEMBLE CYLINDER THRU HOLE IN COVER WITH CAM IN POSITION AS SHOWN. POSITION THREAD NUT ON CYLINDER AND TIGHTEN AS SHOWN DOOR (USE NOTCHES IN NUT IF NECESSARY) HORIZONTAL TEST CYLINDER WITH KEY FOR FREE REFERENCE LINE ROTATION, CAM MUST ENGAGE SWITCH. CHASSIS ALARM: AND KEYWAY

417/10"*

ELECTRONIC

MODULE

INSIDE

SWITCH

MUST FACE

DOWN

E MOUNT COVER AND STRIKE