MATERIAL SAFETY DATA SHEET

Dura Lube Corporation May be used to comply with OSHA's 102-3 Hamilton Avenue Hazard Communication Standard

| Stamford, CT 06902

(800) 424-9300 - Chemtree requirements

SECTION I IDENTIFICATION

Trade Name: Precision Blend 100% Synthetic Grease

Product Code: HL-SL057 DOT Class: Non-Regulated

Chemical Class: Petroleum Hydrocarbon, Synthetic

SECTION II HAZARDOUS INGREDIENTS IDENTITY INFORMATION

Hazardous Components CAS# OSHA PEL ACGIH TLV Inorganic Thickener 71011-27-3 15ppm 10ppm

Other components, if any, are considered to be non-hazardous as per OSHA 29 CFR 1910.1200 SECTION III PHYSICAL & CHEMICAL CHARACTERISTICS

Flash Point: 500° ASTM D92 Cleveland Open Cup

Specific Gravity (H20=1): 0.86 @ 15.6°C

Vapor Density (Air=1): NA Evaporation Rate (N-BA=1): NA

Weight (lb./gal.): 7.18 Solubility in Water: Negligible

Vapor Pressure: 1.0 mm HG @ 20°C

Appearance & Odor: Amber grease, odor of mineral oil

Dropping Point: 600°F

Worked Penetration: 265-295

Operating Temperatures: Lower-30°F / Max Sustained 350°F / Max Intermittent 400°F

SECTION IV FIRE & EXPLOSION HAZARD DATA

Extinguishing Media: Use water fog, foam, carbon dioxide, or dry chemical. DO NOT

use a direct stream of water, product will float and can be

reignited on surface of water.

Special Fire Fighting Procedures: Use self contained breathing apparatus.

Unusual Fire & Explosion Hazards: Heating of non-vented container may cause explosion. Keep

surrounding containers cool with water spray. Flammable Limits: Lower N.D. Upper N.D. % volume in air.

SECTION V REACTIVITY DATA

Stability: Stable

Conditions to Avoid: Contact with open flame.

Hazardous Decomposition Products: Carbon Monoxide and unidentified organic compounds may form during combustion.

Hazardous Polymerization: Will not occur

SECTION VIHEALTH HAZARD DATA

SIGNS AND SYMPOMS OF EXPOSURE:

Eyes: Believed to be minimally irritating.

Dermal: Believed to be minimally irritating.

Inhalation: Believed to be minimally irritating if not in excess of permissible

concentrations.

EMERGENCY AND FIRST AID PROCEDURES:

Eyes: Flush with large amounts of water for 15 minutes.

Dermal: Remove contaminated clothing and wipe excess off. Wash with soap and

water or a waterless hand cleaner followed by soap and water.

Inhalation: Remove victim to fresh air and provide oxygen if breathing is difficult. Get

medical attention.

Ingestion: In general, no treatment is necessary unless large quantities of product

are ingested, however, get medical attention.

NOTE to Physician: In general, emesis induction is unnecessary in high viscosity, low volatility

products, i.e. most oils and greases.

Acute Health Hazards: Mild irritation of skin and eyes.Chronic Health Hazards: None expected at the industrial level.

Carcinogenicity: This product is NOT listed as a known carcinogen or possible

carcinogen NOR does it contain components which are considered

Carcinogenic by OSHA, NTP, or IARC.

SECTION VIISPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:

Contain spill if possible, wipe up or absorb on suitable material and shovel up.

WASTE DISPOSAL METHOD:

In accordance with Local, State and Federal Laws. Under RCRA, it is the responsibility of the userof products to determine, at time of disposal, whether product meets RCRA criteria of hazardous waste.

SECTION VIIISPECIAL PROTECTION INFORMATION

Respiratory Protection: None required if exposures are within permissible concentrations.

Ventilation: Mechanical to maintain good air flow.

Protective Gloves: Oil resistant gloves.

Eye Protection: Chemical type goggles or face shield.Other: As needed to minimize skin contact.

Hygienic Practices: Always wash face and hands and skin after contact.

Storage: Store in a cool, dry place with adequate ventilation, keep away from flames.

SECTION VII

The information contained herein is based on data considered accurate. However, no warranty is expressed or impliedregarding the accuracy of this data or results to be obtained from the use thereof. Vendor assumes no responsibility for injuryto vendee or third person proximately caused by the material if reasonable safety procedures are not adhered to as stipulatedin the data sheet. Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused byabnormal use of the material even if reasonable safety procedures are followed. Furthermore, vendee assumes the risk in the use of this material.