Dexter ED1000T Pull Plate Wide Stile Trim Template 111058 Installation Instructions

PULL PLATE TEMPLATE FOR USE WITH ANSI GRADE 1 EXIT DEVICES 1 9/16" (39.7mm) __ 25/32"_ _ (19.8mm) 25/32". (19.8mm)5 1/32" 2 9/32" (128mm) (57.5mm) Cylinder Hole Cut out Ø1 5/8"(41mm) Hole on Pull Side (Not require for Dummy Pull Plate) 1/4" (6mm) PULL PLATE ♠ CORRESPONDS TO EXIT DEVICE ♠ 2 3/4" (70mm) (76mm) Mounting Holes (4 places) Drill Ø 15/32"(12mm) Holes on Pull Side Drill Ø 5/16"(8mm) Holes on Push Side 8 3/16" (208mm) PULL PLATE & CORRESPONDS TO EXIT DEVICE & NOTE: 5 7/16" (138.5mm) This template is used for Rim and Surface Vertical Rod Exit Devices use, it is not available for Concealed Vertical Rod Exit Device.

REV: 01, 10/2011