Corbin Russwin SE LP10, SN200, and SN210 Series ED5200N and ED5800N Series Rim and CVR 9600 Series Trim Wood or …_T31215

(1) Notes: 1. This template is an addition to the device template. Locate centerlines using horizontal and vertical references on device template. 2. Dimensions are in inches (mm). 3. LHR door shown. (RHR opposite) 4. Provide adequate structural support to maintain door integrity during operation. 5. Prepare mounting holes when installing trim. 6. Dimensions given about a centerline are symmetrical. 7. Unspecified radius 1/8 maximum. 8. Concealed Door Position Switch p/n:708F989 is included with this product. Use and installation location to be specified by others. See SE LP10 (FM385) or SN200/210 (FM563) installation instructions for 9600 SN Series 9600 SE LP10 Series Note: Lever design prefix does not affect door prep. 🕻 Door C Vertical Reference (Trim Centerline) OUTSIDE FACE OF DOOR Ø3/32 (2) x 5/8 (16) Deep Outside Face Inside Face Outside Only 7/16 Of Door Of Door (2 Places) (11)(4 Places) Ø3/32 (2) x 1-1/4 (32) Deep Inside Only Ø3/8 (10) Wire Raceway (6 Places) From Hinge Edge Power Thru Source To Ø1 (25) Hole (38) 7/8 (22)R1/4 (6) Thru Ø3/4 (2 Places) (35)(16)1 - 3/8R1/4 (6) x 1/4 (6) Deep 3-5/8(2 Places) (92)(51) L Horizontal Reference (Device and Trim Centerline) 3/4 Dia. (19)3-5/8(92)-Radius Trim Cutout (25)Outside Face 11/16 1/2 (13) Dia. 1-1/4(17.5)(32)Thru Door (4 Places) (4 Places) X Section X - X RESPONSIBILITY DOOR AND FRAME MANUFACTURERS ARE SE LP10, SN200/210 RESPONSIBLE FOR PROVIDING ADEQUATE 9600 Series Trim CONSTRUCTION OR REINFORCEMENTS FOR assa abloy PROPER INSTALL ATION OF HARDWARE SHOWN for ED5200N/ED5800N Series Exit Devices ALL ARCHITECTURAL BUILDERS HARDWARE MUST Wood or Composite Door Preparation SUPERSEDES BE INSTALLED ON PROPERLY REINFORCED DO NOT SCALE DRAWING T31215 DOORS AND FRAMES, REGARDLESS OF TYPE. 12/20 MATERIAL, OR METHOD OF CONSTRUCTION. T31215-1

LHR Door RHR Door Inside Face of Door ONLY

RESPONSIBILITY

DOOR AND FRAME MANUFACTURERS ARE RESPONSIBLE FOR PROVIDING ADEQUATE CONSTRUCTION OR REINFORCEMENTS FOR PROPER INSTALLATION OF HARDWARE SHOWN. ALL ARCHITECTURAL BUILDERS HARDWARE MUST BE INSTALLED ON PROPERLY REINFORCED DOORS AND FRAMES, REGARDLESS OF TYPE, MATERIAL, OR METHOD OF CONSTRUCTION.

SE LP10, SN200/210 9600 Series Trim for ED5200N/ED5800N Series Exit Devices Wood or Composite Door Preparation

®

ASSA ABLOY

www.corbinrusswin.com

T31215

TEMPLATE NUMBER SHEET DATE T31215-1 2 of 2 12/20

DO NOT SCALE DRAWING SUPERSEDES

Experience a safer and more open world