Arrow CLK‐10 Cam Lock Kit Installation Instructions

Open the original PDF document

Arrow CLK‐10 Cam Lock Kit

Length	Required Components
9/16"	¼" Spacer and Offset Cam Inward
13/16"	Offset Cam Inward
15/16"	¼" Spacer and Straight Cam
1 3/16"	Straight Cam
1 5/16"	¼" Spacer and Offset Cam Outward
1 9/16"	Offset Cam Outward

Additional spacers from 1/16" to 7/16" thick available for other grip lengths. Sold only as separate parts.

1. For ¾" round hole installations, secure anchor washer into back of mounting surface to provide "double d" mounting hole. Flats normally installed vertically.
2. Place spacer over cylinder (if needed). Insert cylinder into "double d" mounting hole. Keyway typically is located at 6 o'clock in locked position. Secure cylinder in place with hex nut.
3. Insert pin through back of cam, orient stop on cam and pin (reference Cam, Pin, and Stop Configuration Table on the next page). With cylinder in locked position, place stop, cam, and drive pin onto rear of lock.
4. Insert screws (2) through captive or non‐captive drive as required. Fasten to rear of lock per drive configuration table.
5. Insert key and test function.

1. The Arrow CLK‐10 cam lock is pinned according to the A2 pinning specification. Due to the lack of a control shear line and the diameter of the lock, the total stack height is 12.
2. A special cap, Arrow part number IPKNCVR, is required to cap the cylinder.