EXIT DEVICE INSTALLATION INSTRUCTIONS

K-103 SWITCH KIT

SARGENT 80 SERIES EXIT DEVICES, ARROW 1000, 3000 & 4000 SERIES EXIT DEVICES AND DOREX 9500 SERIES EXIT DEVICES SWITCH MONITORS EGRESS BY PUSHBAR ACTIVATION OF EXIT DEVICE

CENTER LINE OF DEVICE CHANNEL

ELECTRICAL SPECIFICATIONS

• SPDT MONITOR SWITCH
• CONTACT RATING: 4 AMP @ 250VAC

COLOR CODE FOR WIRES

• YELLOW WIRE: COMMON
• RED WIRE: NORMALLY OPEN
• GRAY WIRE: NORMALLY CLOSED

SWITCH ARM LOCATED UNDER PUSHBAR PIVOT AS SHOWN

DRILL AND TAP FOR #6-32 THREADED

HOLE TYPICAL 2 PLACES.

INSTALLATION INSTRUCTIONS

STEP 1: REMOVE END COVER FROM CHANNEL.

STEP 2: LOCATE CENTER OF CHANNEL, THEN MARK DIMENSIONS AS SHOWN.

STEP 3: AFTER DIMENSIONS ARE MARKED CENTER PUNCH FOR 2 DRILL HOLES.

USE A #36 (.106 DIA.) DRILL BIT FOR PROPER TAP DRILL SIZE.

STEP 4: DRILL HOLES FOR BRACKET, NEXT USING A #6-32 TAPER TAP, TAP THE 2 HOLES.

STEP 5: DEBURR HOLES SO THAT BRACKET WILL SIT FLAT.

STEP 6: DEPRESS PUSHBAR THEN MAKE SURE THAT SWITCH ARM IS LOCATED UNDER END OF PIVOT,

THEN SECURE BRACKET WITH PROVIDED HARDWARE.

STEP 7: SWITCH SHOULD FUNTION AS FOLLOWS: SWITCH ARM SHOULD BE ACTIVATED WHEN PUSHBAR IS IN RELAXED POSITION.

SWITCH ARM SHOULD DE-ACTIVATE WHEN PUSHBAR IS DEPRESSED.

STEP 8: MOUNT DEVICE, TERMINATE WIRES ACCORDINGLY WITH PROPER WIRE NUTS OR CRIMPS.

5/16"